Marble Peel and Stick Tile Stickers

What these tile stickers are

These are self-adhesive tile stickers made from PVC vinyl, PET, and XPE foam. The top layer carries a printed marble pattern. The middle gives the sheet a slight cushion and helps it sit flat. The backing peels away to expose a sticky side that presses onto your surface.

You do not need grout, thin-set, or special tools. Cut a sheet to size with scissors or a utility knife, peel the backing, and press it into place. The result reads as tile from a normal viewing distance, with a smooth surface you can wipe clean.

Sizes and coverage

Each sheet is a square. The table below shows how many sheets you get and the total area they cover.

Measure your space before you order. Add a little extra for cuts and edges. A typical kitchen backsplash behind a stove and counter often needs 20 to 40 sheets. A small bathroom vanity wall may need 10 to 20.

Colors

Five marble looks are available:

• Gray marble: cool gray veins on a light base
• White marble: soft gray veining on white
• Golden marble: warm gold and beige tones
• Black marble: dark base with light veining
• Pandora marble: bold contrast with dramatic veining

Each color comes in 10, 20, or 40 sheet packs. Pick the pack size that matches your area, or mix colors if you want a border or accent strip.

Where they can go

These stickers are made for smooth, flat, dry walls. They also work on tile, glass, metal, and wood. Common spots include:

• Kitchen backsplash behind a counter or stove
• Bathroom vanity wall or behind a sink
• Rental kitchen or apartment updates
• Laundry room or mudroom walls
• Cabinet fronts, shelves, or table tops
• Floor accents in small areas

The surface must be clean and dry before you start. Wipe away dust, grease, and soap residue. Let the surface dry fully. If the wall has texture, bumps, or peeling paint, the sticker may not sit flat.

How to fit them

1. Clean the surface and let it dry.
2. Measure the area and plan your layout. Start from a corner or a straight edge.
3. Cut a sheet to size with scissors or a utility knife. Leave a small margin at edges if you plan to trim later.
4. Peel a few inches of backing away from the top edge.
5. Press the top edge onto the surface and smooth it down with your hand or a soft cloth.
6. Keep peeling the backing as you press the rest of the sheet down.
7. Smooth out air bubbles by pushing them toward the nearest edge.
8. Trim any overhang with a utility knife.

For a tile look, leave a thin gap between sheets or butt them together. Both read well. On a backsplash, work from the bottom up so gravity helps you keep lines straight.

Care

Wipe the surface with a damp cloth. For grease or soap film, use a mild dish soap and water, then wipe dry. Avoid abrasive pads, harsh solvents, or scraping tools. These can dull the print or lift the edge.

If an edge lifts, press it back down. A little warmth from a hair dryer on low can help the adhesive grip again. Do not use a heat gun.

Before you order

Check that your wall is smooth, flat, and dry. Textured walls, fresh paint, and damp areas can shorten how well the sticker holds. Order enough sheets in one go so the pattern and color match across your project. Keep a spare sheet or two for future repairs.