Quiet Grip Carpet Floor Squares

What these carpet squares are

Quiet Grip Carpet Floor Squares give you a soft, quiet surface without glue, nails or an installer. Each square is made of cut pile PVC carpet with a self-adhesive backing. You press it down, and it stays. The pile feels warm underfoot, which makes these squares a good fit for bedrooms, dining rooms, kitchens and other indoor spots where bare floor feels cold or loud.

The surface is solid in color, with a low, even pile that hides everyday dust and footprints. The backing is polyvinyl chloride (PVC), the same family of material used in many peel and stick floor products. No high-concerned chemicals are listed for this item.

Sizes, coverage and pack options

Every sheet is the same size. The pack you choose sets how much floor you cover.

Measure your space before you order. For a small entry or a reading nook, 5 sheets is often enough. For a full bedroom or dining area, the 10 sheet pack gives you more room to work. If your floor is an odd shape, sketch it and count the squares you need, then add a few for cuts around doorways and corners.

Colors and styles

Pick the tone that matches your room:

• Light gray
• Black
• Dark gray
• Beige
• Brown
• Deep blue
• Khaki
• Light gray, B pattern
• Dark gray, B pattern
• Brown, B pattern

The solid colors keep a room calm and simple. The B pattern styles add a subtle repeat across the floor, which works well when you want a little texture without a loud design. You can lay one color wall to wall, or mix two colors in a checkerboard or border layout.

How to fit and use them

These squares are a peel and stick flooring option, so the steps are short.

1. Clear the floor and sweep or vacuum it. The surface should be dry, flat and free of grit.
2. Let the squares sit in the room for a few hours so they settle to room temperature. This helps the backing grip.
3. Plan your layout. Start at a straight wall or in the center of the room, and work outward.
4. Peel the backing film from one square and press it onto the floor. Start at one corner and smooth it down with your hand.
5. Butt the next square tight against the first. Keep the seams lined up as you go.
6. For edges, place a square over the gap, press it down, then trim along the wall with a utility knife.
7. Roll or press the whole floor once more when you finish.

A few notes that help the result last. Keep the squares out of standing water. Wipe spills soon after they happen. If you lay them over a hard, smooth floor, the backing has the best surface to hold. On a rough or uneven floor, the grip can be weaker. These squares are for indoor use.

Care and everyday upkeep

Vacuum these squares like you would a low pile rug. For spots, use a mild soap and water mix and a cloth or soft brush. Blot rather than soak, and let the area air dry. A quick pass with a vacuum keeps the pile looking even. If a square ever lifts at a corner, press it back down. If you want to remove the floor later, lift a corner and peel the square up. The self-adhesive backing is made to release, though the result depends on your subfloor and how long the squares have been down.

Where they work best

Use them in bedrooms, dining rooms, kitchens, home offices and indoor hallways. They suit renters who want a floor change without a permanent install, and homeowners who want a soft landing in a small space. Because each square is a single-piece unit, you can replace one square without redoing the whole floor.