Soft 3D Wall Panel Roll

What This Wall Panel Roll Is

This is a roll of flexible wall paneling with a soft 3D surface that resembles ceramic tile. The material is matte PVC vinyl, so it bends around corners and follows the shape of your wall without cracking. A self-adhesive backing covers the whole sheet. You peel the liner and press the panel into place. No glue, no grout, no tools beyond a cutter and a smooth cloth.

The finish is waterproof, mildew resistant, and moisture proof. That makes the roll a practical choice for bathrooms, kitchen backsplashes, laundry rooms, and other spaces where splashes happen. The matte surface keeps glare low, so the texture reads clearly under both natural and overhead light.

Size and Coverage

Each roll is a single sheet, not a pack of tiles. One roll covers 15.7 x 118.1 in (40 x 300 cm), which is about 12.9 sq ft. Order several rolls for a full wall, and line up the pattern edge to edge as you go.

Measure your wall before you order. Add a little extra to the width and height so you can trim the edges clean. If you are covering a large wall, divide the total width by 15.7 in (40 cm) to see how many rolls you need side by side.

Colors

Pick from four matte shades:

• White: bright and clean, good for small rooms and light kitchens
• Beige: warm and soft, pairs well with wood cabinets and cream tile
• Light gray: a quiet neutral for modern baths and laundry rooms
• Dark gray: deeper contrast for accent walls and darker cabinets

All four colors share the same 3D texture and the same matte PVC vinyl finish.

Where It Works

The self-adhesive backing holds on smooth painted walls, tile, and glass. Clean, flat surfaces give the best result. Skip rough brick, unfinished concrete, and freshly painted walls that have not fully cured.

Common uses include kitchen backsplashes, bathroom walls, vanity surrounds, laundry room walls, rental kitchen updates, and cabinet doors. Because the roll is waterproof and moisture proof, it handles steam and splashes well in daily use.

How to Fit It

1. Clean the surface. Wipe away dust, grease, and soap film, then let it dry fully.
2. Measure and cut. Add about 1 in (2.5 cm) to each side for trimming.
3. Peel a short section of the backing. Press the top edge into place.
4. Work downward in small sections. Peel and press as you go, smoothing with a cloth or squeegee to push out air.
5. Trim the edges with a sharp cutter. Press the seams flat where two rolls meet.

For the best bond, press firmly across the whole panel after it is up. If you need to reposition a corner, lift it slowly and lay it back down.

Care

Wipe the surface with a soft damp cloth and mild soap. Avoid abrasive pads, strong solvents, and scrubbing brushes, which can dull the matte finish. The waterproof and mildew resistant surface stands up to regular bathroom and kitchen cleaning. To remove the panel later, warm the edge with a hair dryer on low, then peel slowly and pull away any residue.