Beige Frosted Static Cling Privacy Window Film

What this window film is

This is a matte PE vinyl film that goes on glass with static cling. There is no adhesive and no glue, so you do not need paste, a squeegee kit or any special tools to put it up. The surface has a frosted, etched look that softens the glass and hides what is behind it.

The film gives full privacy. It blocks the view in both directions, so people outside cannot see in and you cannot see out through the covered area. That makes it a good fit for street-facing windows, bathroom glass, front doors with glass panels and office partitions.

It is made for flat single or double glazing. The color is Beige, a warm neutral that reads soft against most frames and trim.

Sizes

Pick the size that matches your glass. Each option is listed in inches first, with the metric value in brackets.

Measure your glass before you order. Add a little extra to the width and height if you plan to trim the film down to fit. A single roll covers one window or one panel, depending on the size you choose.

Color

This film comes in Beige. It is a light, warm tone that keeps the glass looking clean rather than dark. Because the finish is matte, it does not throw a glare back into the room the way a glossy film can.

If you are covering more than one window, order the sizes you need in the same color so the panels match.

How to fit it

Static cling film goes on with water, not glue. Here is a simple way to do it.

1. Clean the glass with a damp cloth and let it dry. Dust and grit will show through the film.
2. Measure the glass and cut the film a little larger than the pane.
3. Wet the glass with clean water. A spray bottle works well.
4. Peel the film from its backing and press it onto the wet glass.
5. Smooth it out from the center to the edges to push out water and air.
6. Trim the edges with a sharp knife or scissors.

If you see a bubble, lift that corner and press it back down while the glass is still wet. Static cling film can be peeled off and repositioned while it is wet, so you can take your time.

This film is for flat glass. It is not made for curved glass, textured glass or glass with a deep frame that stops the film from lying flat.

Care

Wipe the film with a damp cloth when it needs a clean. Do not scrub it with abrasive pads or strong cleaners. A soft cloth and water are enough.

Where it works

Use it on bathroom windows, front door glass, kitchen windows that face a neighbor, rental windows where you cannot drill or add hardware, and office glass that needs a private look. Because it clings without glue, it comes off cleanly when you want to change it.