Black Forest Floral Peel and Stick Wallpaper

What this wallpaper is

This is a self-adhesive vinyl wallpaper with an embossed surface. The raised texture gives the floral forest pattern a soft, dimensional look that reads well in both bright and low light. The backing is already sticky, so you do not need paste, glue or a separate adhesive. When you want a change, the paper peels off without residue.

The surface is water-resistant, mildew resistant and moisture-proof. The vinyl wipes clean with a damp cloth.

Sizes

Every roll is 17.7 in (45 cm) wide. The length you pick sets how much wall you can cover. Measure your wall height and width first, then choose the roll that fits with a little extra for trimming.

If you are covering more than one wall, order all the rolls at once so the pattern and finish match.

Color and style

The color is Black forest floral. The design is a dark forest scene with floral details, drawn in a Southeast Asia style. Deep greens and blacks sit against lighter leaf shapes, so the pattern feels layered rather than flat. The embossed surface adds a subtle texture you can see and feel.

This pattern suits a living room, bedroom, study, kitchen or kids' room wall. It works as a full wall or as a single panel behind a bed, a sofa or a shelf. In a study, it can sit behind a desk to soften the view.

How to fit it

1. Clean the wall. Wipe off dust, grease and loose paint. Let the surface dry fully.
2. Measure twice. Mark the height you need and add a few inches for trimming.
3. Cut the roll to length on a flat surface. Use sharp scissors or a craft knife.
4. Peel back a few inches of the backing at the top. Press the paper to the wall and smooth it down with your hand or a soft cloth.
5. Keep peeling and pressing in small sections. Work from the center out to push air to the edges.
6. Trim the top, bottom and sides with a knife against a straight edge.
7. Smooth the whole panel once more. Small bubbles often settle within a day.

The paper sticks best to smooth, flat walls. On textured or freshly painted walls, test a small corner first. You can remove and reposition a panel while the backing is still partly on. Once the full backing is off and the paper is pressed down, it holds in place.

Care

Wipe the surface with a damp cloth and mild soap when needed. Avoid abrasive pads and strong solvents, which can dull the embossed finish. The paper is water-resistant, mildew resistant and moisture-proof, so a quick wipe is fine. Keep it out of standing water and away from direct heat.

If a corner lifts, press it back down with a clean, dry cloth. For a full removal, start at a top corner and pull the paper back slowly and evenly. The adhesive releases without residue on most smooth walls.