Vintage Blue Floral Vinyl Wallpaper

What it is and what it is made of

This is a self-adhesive vinyl wallpaper with a blue and white floral print. The backing is already adhesive, so you do not need paste, glue or special tools. Cut the roll to length, peel the backing away and press the paper onto the wall.

The vinyl surface is water-resistant, which makes it simple to wipe clean with a damp cloth. The print has a vintage feel, so it suits bedrooms, living rooms, studies and rental spaces where you want pattern without a permanent commitment.

Sizes and coverage

Each roll is 17.3 in (44 cm) wide. Pick the length that matches your project.

Measure your wall before you order. Multiply the width by the height to get the square footage you need, then compare that number with the coverage of each roll. For a full wall, buy enough rolls from the same order.

Color and pattern

The design uses blue and white florals on a light background. The blue reads soft rather than bright, which keeps the look calm and traditional.

This style works well in bedrooms, living rooms, studies and entryways. It also suits rental kitchens and bathrooms when applied to tile or glass, as long as the surface is smooth and clean.

Where it can go

This wallpaper is made for smooth painted walls, tile and glass. Those surfaces give the adhesive a flat, even grip. Textured walls, brick, raw wood and unfinished drywall are not good candidates because the paper cannot sit flush against the surface.

Before you start, wash the wall with a mild cleaner and let it dry fully. Wipe away dust, grease and soap film. A clean surface helps the adhesive hold and makes removal easier later.

How to apply it

1. Measure the height of your wall and add a few inches for trimming.
2. Cut the roll to that length with scissors or a craft knife.
3. Peel back a few inches of the backing at the top.
4. Press the top edge to the wall and smooth downward with your hand or a soft cloth.
5. Continue peeling the backing as you go, pressing out air bubbles as they appear.
6. Trim the excess at the top, bottom and sides.

Work in small sections. If a bubble forms, lift that corner and press it back down slowly. A second pair of hands helps on long walls.

Care and removal

The vinyl surface is water-resistant. Wipe it with a soft, damp cloth and a mild household cleaner when needed. Avoid abrasive pads and strong solvents, which can dull the print.

When you want a change, peel the paper off slowly from a top corner. Pull at a low angle, close to the wall, and the adhesive should release without leaving residue behind. On painted walls, go slowly so the paint stays intact. On tile and glass, removal is usually quicker.

What to keep in mind

This is a self-adhesive vinyl wallpaper, not a fabric or paper-backed paste product. It is not designed for ceilings, outdoor surfaces or rough walls. It is also not a substitute for paint on damaged drywall. For the best result, apply it to a smooth, clean, dry surface and press every edge firmly.