Color Shift Reflective Window Tint

What this film is

Color Shift Reflective Window Tint is a self-adhesive PVC film that changes color as the light hits it. The reflective surface gives glass a semi-private, one-way view, so you can see out while the outside sees mostly reflection. It works on flat single or double glazing and adds a decorative finish along with UV protection and explosion-proof backing.

Sizes

Each roll is 19.7 in (50 cm) wide. Pick the length that matches your window or door:

Measure your glass before you order. Add a little extra to your measurement so you can trim the edges cleanly after fitting.

Colors

Five shades are available: red, green, gold, blue and silver. Each one shifts tone as the angle of light changes, so the glass looks different through the day. Red and gold lean warm, green and blue lean cool, and silver stays closest to a classic mirror finish. All five give the same semi-private, one-way view.

How to fit it

1. Clean the glass with plain water and let it dry. Dust, grease or soap residue can show under the film.
2. Measure the pane and cut the film about 1 in (2.5 cm) larger on each side.
3. Peel back a few inches of the self-adhesive backing.
4. Press the film onto the glass and smooth it outward with a squeegee or a soft cloth.
5. Work out air bubbles as you go, peeling the backing away a little at a time.
6. Trim the overhang with a sharp blade against the frame edge.

For a smoother result, mist the glass lightly with water before you press the film down. The water lets you slide the film into place, then you push it out from the center. Small bubbles usually settle within a few days.

Where it works

Use it on flat single or double glazing at home. Good spots include street-facing windows, front doors with glass panels, bathroom windows and patio doors. The one-way view works best when the side with more light stays outside, which is how most homes are set up during the day. At night, close a curtain or blind if you want full privacy.

Care

Wipe the film with a soft cloth and mild soapy water. Skip abrasive pads, ammonia cleaners and sharp tools, which can dull the reflective finish. To remove the film, lift a corner and pull it back slowly. The self-adhesive backing comes away from glass without leaving a sticky layer in most cases. Store unused rolls flat, out of direct sun, until you are ready to fit them.